Unworn
How to
Needed
- A squeegee (included).
- Waterspray bottle.
- 100 ml water + 1 drop of mild dish soap.
- Clean cloth.
Tips & Notes
- Work in a clean, dust-free environment.
- Indoor temperature between 18–25°C is ideal.
- Small water pockets after installation are normal. They will gradually disappear as the film cures. Do not peel the film back to remove tiny bubbles.
- Contact us if you need any help.
Thoroughly clean your snowboard top sheet. Use an alcohol based cleaner to remove dirt, oil and wax.
Peel the backing liner away while holding the film in the air. Avoid touching the adhesive side. The arrows mark the nose of the board.
While holding the film, generously spray the exposed adhesive side and the snowboard with solution.
Align the film with the binding inserts and edges. Do not stretch it. Make sure it sits evenly on the board.
Use a soft squeegee to push the water and air out in overlapping strokes, working from the center towards the edges.
Gently squeegee towards the edges and remove any remaining water.
Inspect the entire board. Squeegee out remaining water and make sure all edges are secure.
Let the film cure for at least 24 hours. Do not wash or ride the board during this time.
You're all set. Enjoy the ride with ultimate protection for your board.